Description
Right rear lamp for Peugeot 207, 3- and 5-door models (up to 2009).
Upgrade your Peugeot 207 with an exact-fit right rear lamp assembly designed to restore safety and visual integrity after damage or wear. This replacement part matches original mounting points and electrical connections for easy installation in workshop environments or home garages. Commonly searched by part numbers 9649986580 and 6351Y7, this lamp improves night-time visibility and ensures correct signalling performance for brake, tail and indicator functions.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 207 (3-Door, 5-Door)
- Product Codes: 9649986580
- Additional Numbers: 6351Y7
Application And Compatibility
Fits Peugeot 207 models with right-side rear combination lamp layout, produced up to model year 2009. Verify that the mounting points and connector shape match your vehicle — this unit is intended as a direct replacement for the original right rear lamp on the specified body variants.
Function And Features
- Rear combination lamp providing tail light, brake light and turn signal functions. Depending on the specific vehicle variant, the unit may also incorporate reverse or rear fog lamp functions.
- Designed to match original exterior contours and reflectors for correct light distribution and road legality.
- Uses the original-style connector and bulb sockets or LED modules depending on the factory configuration.
Installation Recommendations
Recommended for professional mechanics and experienced DIYers. Typical replacement steps:
- Park the vehicle on level ground and switch off ignition.
- Disconnect the negative battery terminal before starting work to prevent short circuits and protect vehicle electronics.
- Access the lamp from inside the boot by removing the trim or access panel covering the lamp mounting area.
- Unscrew the lamp retaining bolts, carefully withdraw the lamp assembly and unplug the wiring connector.
- Transfer bulbs or socket assemblies if required, fit the new lamp, connect the wiring harness and secure all fasteners to the original mounting points.
- Check all light functions (tail, brake, indicator, reverse/fog if present) after installation. Ensure seals and mating surfaces are clean to avoid water ingress.
Use caution handling bulbs and lenses — avoid touching bulb glass with bare hands. Replace damaged seals and mounting clips to maintain correct fitment and prevent moisture entry.
Why The Part Most Often Fails
- Impact Damage: Rear-end knocks or parking collisions commonly crack the lens or break mounting tabs.
- Water Ingress: Seal failure or cracked housings allow moisture to enter, causing corrosion of sockets and electrical faults or condensation that reduces light output.
- Age And Heat Cycling: Over time, exposure to heat and vibration can degrade seals, plastic tabs and bulb holders.
- Bulb Or Socket Failure: In versions with replaceable bulbs, worn or corroded sockets cause intermittent lighting or complete failure.
Practical Tips
- Inspect lamp seals and mounting points during routine service to catch early signs of damage.
- If you experience intermittent signalling, check the connector and bulb contacts for corrosion before replacing the entire unit.
- Keep one spare bulb type on hand if your vehicle uses replaceable bulbs; for LED versions, inspect the whole unit for damage and moisture.
