Description
Bulb Socket For The Right Rear Lamp Of PEUGEOT 207 3- And 5-Door Models. From 2010 With LED Lighting.
Description
High-quality replacement bulb socket designed for the right rear tail light of Peugeot 207 (3- and 5-door). This direct-fit socket restores secure electrical contact and correct bulb positioning in assemblies used from 2010 on models equipped with LED lighting. Ideal for professional garages and DIY enthusiasts who need a reliable, easy-to-install part identified by common OE references.
Benefits And Application
- Direct Replacement: Designed to match original geometry and electrical contacts for an accurate fit.
- Durability: Resistant to vibration and temperature variations typical of rear light assemblies.
- Service Friendly: Replaces worn or corroded sockets that cause intermittent lighting or failure.
- SEO Keywords: Peugeot 207 bulb socket, rear tail light socket 9686565980, 6351HQ, right rear lamp socket.
Technical Information
- Manufacturer: Peugeot (Stellantis)
- Model: Peugeot 207 3-Door And 5-Door
- Product Codes: 9686565980, 6351HQ
- Additional Numbers: 6351HQ (alternate reference)
Installation Recommendations
Intended for fitment by trained technicians or experienced DIYers. Typical replacement steps:
- Switch Off Ignition And Remove Key. For added safety, disconnect the battery negative terminal when working on vehicle electrics.
- Open Tailgate And Remove Interior Trim Or Access Panel To Reach The Rear Lamp Assembly.
- Unscrew Or Unclip The Lamp Unit From The Body, Then Access The Bulb Socket From The Rear Of The Assembly.
- Unplug The Wiring Harness Connector, Release Any Retaining Clips And Twist/Pull The Old Socket Out Of The Lamp Housing.
- Install The New Socket Ensuring Correct Orientation, Reconnect The Harness And Secure Clips Or Screws. Replace Bulb If Damaged.
- Reassemble Trim And Test All Light Functions (Brake, Tail, Indicator, Reverse As Applicable) Before Finalizing.
- Use Dielectric Grease On Contacts If Exposed To Moisture To Improve Longevity And Prevent Corrosion.
Why This Part Fails Most Often
- Corrosion Of Electrical Contacts Caused By Moisture Ingress Or Damaged Seals.
- Heat Damage From Overheated Or Incorrect Bulbs Causing Plastic Deformation.
- Mechanical Wear Or Vibration Leading To Poor Contact Or Cracked Housing.
- Contaminants Or Salt Exposure Accelerating Electrical Failure In Regions With Winter Road Treatment.
Notes For Professionals
This socket is commonly sought under OE numbers 9686565980 and 6351HQ. When replacing, check the lamp housing seals and bulb condition—replacing the socket without addressing a leaking housing or a failing bulb may lead to repeated faults. After installation, verify full functionality of the rear light cluster.
