Left Rear Lamp Socket With Wiring For Peugeot 206 Up To 06/2003 6350P1

Description

Socket for the left rear lamp with wiring for PEUGEOT 206 3/5-door models up to 06/2003. Supplied with a short length of wiring. Driver Side. Not rusty or heat-damaged, fully functional; functionality of the bulbs is not guaranteed.

This left rear lamp socket and wiring piece is a direct-fit replacement designed for Peugeot 206 owners, workshops and DIY mechanics who need a reliable lamp holder for tail, brake and indicator bulbs. The part restores secure electrical contact and correct bulb positioning while avoiding intermittent faults caused by worn contacts or damaged cable ends. It is particularly useful when the original socket shows signs of contact wear, melting or when a small section of wiring is damaged.

Technical Information

• Manufacturer: Peugeot (Stellantis)
• Model: Peugeot 206 (3/5 Door) up to 06/2003
• Product Codes: 6350P1
• Other Numbers: Not Available

Fitment And Application

Designed for the left (driver) rear lamp on Peugeot 206 3 and 5-door variants produced until June 2003. Fits the lamp cluster assembly and accepts the standard rear lamp bulbs used on these models. Ideal for replacing a damaged socket or repairing a short length of wiring where the original connector is still serviceable.

Function And Common Failures

The socket secures rear lamp bulbs in the cluster and provides the electrical connection for tail, brake and indicator functions. Common causes of failure include corrosion from moisture ingress, heat damage from poor bulb contact, broken or bent terminals, mechanical fatigue from vibration and chafing of the wiring insulation. Replacing the socket eliminates intermittent contacts and reduces the risk of overheating caused by poor connections.

Replacement Procedure

1. Park the vehicle on a level surface and switch off all lighting.
2. Disconnect the negative battery terminal before starting work to avoid short circuits when handling electrical connectors.
3. Remove the interior trim or access panel in the tailgate/boot to reach the rear lamp assembly.
4. Unscrew or unclip the lamp cluster and gently pull it out to access the bulb holder.
5. Unplug the old socket from the lamp cluster or cut back to sound wiring if the original connector is damaged and splice in the supplied wiring section.
6. Install the new socket, ensuring proper seating of bulb contacts and secure mechanical fitment of the lamp cluster.
7. Reconnect the battery and test all rear lamp functions (tail, brake, indicator). Replace any non-working bulbs as required.

Installation Recommendations

• Always disconnect the battery before working on vehicle electrics.
• Use proper connector crimps or solder and heatshrink for splices to ensure a durable electrical and mechanical connection.
• Apply a light coating of dielectric grease to contacts to help prevent future corrosion.
• Check and secure wiring to avoid chafing against sharp edges or moving parts.
• Verify all lamp functions after installation and replace any bulbs that fail to illuminate—bulbs are not included and their functionality is not guaranteed with this part.

Why This Part Fails Most Often

Failures usually stem from exposure to moisture (leading to corrosion), poor contact causing localized heating, or mechanical damage to the wiring and terminals. Vibration over time can loosen terminals, and incorrect bulb fitment or a high-resistance connection can accelerate heat-related deformation of the socket.