Description
Overview
ABS & ESP control unit with integrated hydraulic pump (ATE) designed for Peugeot 206. This unit combines the electronic control module and hydraulic modulator to manage anti-lock braking (ABS) and electronic stability program (ESP) functions. Supplied with wiring harness and original part references for straightforward identification.
Key Functions
The module monitors wheel speed sensors and modulates brake pressure at each wheel to prevent lock-up and help maintain vehicle stability. The integrated pump restores hydraulic pressure when required, while the control electronics execute ABS and ESP interventions during emergency braking or traction loss.
Compatibility And Fitment
Main fitment: Peugeot 206 1.6 HDi (80 kW). Check the part numbers below to confirm compatibility with your vehicle before purchase. The unit is supplied with the associated wiring harness to simplify installation and connection.
Installation Notes
Basic replacement steps (recommended for professional mechanics or experienced DIYers): disconnect the vehicle battery; access the ABS/ESP unit in the engine bay; unplug electrical connectors and remove mounting bolts; carefully disconnect hydraulic lines (expect brake fluid loss); install the replacement unit, reconnect hydraulic lines and electrical connectors; refill and bleed the braking system. After installation, perform a diagnostic scan to clear fault codes and run any necessary initialization or calibration routines.
Common Faults And Causes
Typical Symptoms: ABS or ESP warning lights on the dash, intermittent braking pulsation, loss of ABS function, or reduced stability control intervention.
Common Causes: electrical connector corrosion or poor contact, water ingress, failed pump motor or valves in the hydraulic unit, internal electronic faults, or associated wheel speed sensor failures. Longevity depends on vehicle use and environmental exposure; moisture and corrosion are frequent contributors to module failure.
Recommendations
Inspect wheel speed sensors and wiring when diagnosing ABS/ESP faults to rule out sensor-related triggers. Replace brake fluid if contaminated. Use a professional diagnostic tool after replacement to ensure the unit is properly recognized and any required initialization procedures are completed.
Technical Information
- Manufacturer: PSA Citro&ebreve;n Peugeot / ATE
- Model: Peugeot 206 1.6 HDi 80 kW (With Wiring Harness)
- Product Codes: 9655960880
- Other Numbers: 10.960-1151.3, 10.0206-0194.4, 4541V7, 4542K0
If you are unsure about compatibility, compare the part numbers on your existing unit or consult a professional workshop. Proper installation, bleeding of the brake system and a diagnostic initialization will ensure reliable operation of ABS and ESP functions.
