Description
Left front fog lamp for PEUGEOT 308 T7 cars
Part description
This used left front fog lamp is designed for Peugeot 308 cars and is a practical solution when replacing a damaged or non-functional original part. It is a part from the category of bodywork and lighting components, which is often also searched for by production numbers.
The fog lamp is an important part of the car’s lighting, especially when driving in bad weather conditions. When replacing, it is essential to compare the design of the connectors, the shape of the attachment and the product designation with the existing part on the vehicle.
- Part Type: Left Front Fog Lamp
- Designed for: Peugeot 308 T7
- Usage: replacement for the original damaged or non-functional part
Technical information
Product codes
- Product codes: 9680498680, 6208F0
- Model names: Peugeot 308
Installation recommendations
Generally/typically, the exact method of replacing a fog lamp depends on the specific design of the car and access to the part. Below is a practical general procedure for replacing this type of light fixture.
1) Before assembly
- Check if the left model, body shape, mount and connector match.
- Compare product numbers 9680498680 and 6208F0 with the old part.
- Inspect the headlight housing, brackets and electrical connector for cracks, deformation or excessive wear.
- If a light bulb or other accessories are being transferred from an old piece, check their condition before assembly.
2) Necessary tools and materials
- basic set of hand tools
- screwdrivers or bits according to the type of connecting material
- plastic pry bar for removing covers and linings
- clean cloth
- protective gloves
- contact cleaner if needed
3) Step-by-step assembly procedure
- Secure the vehicle against movement and switch off the ignition.
- Typically disconnect the battery, especially if you will be handling the electrical connector or near other electrical parts.
- Access the fog lamp depending on the design of the car, usually after removing the relevant cover or part of the trim.
- Disconnect the electrical connector of the original headlight and check that the contacts are not dirty or damaged.
- Undo the fasteners of the old part and carefully remove the headlight to avoid damaging the surrounding plastic parts.
- Compare the old and new part side by side – especially the fit, connector and overall shape.
- If necessary, transfer usable accessories from the old part, carefully without violence.
- Place the new fog lamp in the correct position and check that it fits without tension.
- Install the fasteners and tighten them evenly so as not to damage the brackets.
- Connect the electrical connector and verify that it clicks firmly.
- Reinstall any covers or removed parts.
- Connect the battery and perform a basic function check.
-
4) Post-assembly checks and test drive/function verification
- Verify the correct operation of the fog lamp after switching on the lighting.
- Check that the part holds firmly and shows no play.
- Inspect the surrounding parts of the bumper or covers for proper fit after assembly.
- After a short ride, visually verify again that the part has not come loose and the connector remains properly connected.
5) The most common assembly mistakes + how to avoid them
- Swapping left and right parts – always compare the orientation and location of the attachment.
- Damage to the brackets during assembly – do not manipulate the part with force and check for proper seating.
- Insufficiently connected connector – after connecting, check for firm seating.
- Assembly without code comparison – verify numbers 9680498680 and 6208F0 before installation.
- Scratch or contamination of the visible part of the part – use gloves and a clean work area.
Reasons why the part is damaged
- damage from stones, gravel and dirt from traffic
- cracking after a minor impact or contact with an obstacle
- moisture entering the headlight and subsequent deterioration of function
- wear or damage to the electrical connector
- breakage of fastening points during unprofessional disassembly or assembly
