Description
Bulb socket for the right rear lamp with a piece of wiring for PEUGEOT 207 SW. The socket is fully functional, not heat-damaged. Functionality of the bulbs themselves is not guaranteed. Passenger side.
This replacement bulb socket with a short wiring pigtail is intended for the right rear tail lamp of the Peugeot 207 SW estate. It restores the electrical and mechanical connection between the vehicle harness and the lamp bulbs and is frequently searched by part number 6351CT. The design makes it suitable for professional workshops and DIY mechanics who need a direct-fit socket assembly to repair a non-functional rear light circuit.
The component mounts into the rear lamp assembly and provides secure contacts for stop, tail, and indicator bulbs depending on the lamp configuration. It is supplied with a small length of cable to reach the vehicle harness and simplify installation when the original wires or connector are damaged. Because the item is a socket assembly, the actual light bulbs are not included or guaranteed.
Installation Instructions
For Safety, Disconnect The Negative Battery Terminal Before Working On The Lighting Circuit. Typical Replacement Steps:
- Remove The Tail Lamp Assembly From The Vehicle According To The Vehicle Repair Manual.
- Access The Old Socket By Releasing Any Retaining Clips Or Twisting The Socket Out Of The Lamp Housing.
- Disconnect The Old Socket From The Vehicle Harness And Remove It Along With Any Damaged Wiring.
- Fit The New Socket Into The Lamp Housing, Connect The Wire Pigtail To The Vehicle Harness (Use Proper Connectors Or Solder And Heat Shrink Where Required).
- Secure The Wiring To Avoid Chafing, Reinstall The Tail Lamp Assembly And Test All Functions (Brake, Tail, Indicator).
Installation Recommendations
- Clean Connector Contacts And Lamp Socket Receptacles Prior To Fitting To Ensure Good Electrical Contact.
- Apply A Thin Layer Of Dielectric Grease To Contacts To Reduce Corrosion And Moisture Ingress.
- Use Correct Crimp Connectors Or Solder Joints With Heat Shrink For Any Wire Splices To Ensure Long-Term Reliability.
- Route And Fasten The Cable Away From Moving Parts And Hot Surfaces To Prevent Mechanical Damage.
- After Installation, Verify All Lamp Functions And Check For Secure Mechanical Fitment And Proper Alignment.
Why This Part Fails Most Often
- Corrosion And Moisture Ingress Causing Poor Contact Or Intermittent Operation.
- Thermal Stress From Bulb Heat Leading To Brittle Plastic Or Deformed Contacts.
- Vibration And Mechanical Fatigue Resulting In Broken Terminals Or Fractured Wires.
- Damaged Or Melted Wiring Due To Short Circuits Or Poor Electrical Connections.
Technical Information
- Manufacturer: Stellantis / Citroën / Peugeot
- Model: Peugeot 207 SW
- Product Codes: 6351CT
- Additional Numbers: 6351CT
Particularly useful when the original socket or short section of harness is damaged after moisture exposure or impact. Suitable for mechanics and experienced DIYers who require a direct replacement part identified by the 6351CT code.
