Description
Starter for Citroën and Peugeot Vehicles.
Overview
This Bosch starter (part number 0001112041) is a direct-fit replacement commonly used on a range of Citroën and Peugeot petrol models. It delivers reliable cranking performance and is suitable for professional workshops and DIY mechanics who require a durable, OE-compatible unit. Customers frequently search by part number (0001112041, 9647982880, 5802M9, 5802EP), so listing reference codes helps find the correct item quickly.
Applications and Compatibility
Compatible with many small to medium Citroën and Peugeot models equipped with 1.0–1.6 petrol engines. Typical applications include:
- Citroën Berlingo
- Citroën C2
- Citroën C3 / C3 Pluriel
- Citroën C4
- Citroën Xsara / Xsara Picasso
- Peugeot 1007
- Peugeot 206
- Peugeot 307
- Peugeot Partner
Function
The starter converts electrical energy from the battery into mechanical rotation to crank the engine. It integrates an electric motor and a solenoid-operated drive (Bendix) that engages the engine flywheel ring gear. Reliable engagement and sufficient torque are essential for cold starts and repeatability in everyday use.
Typical Failure Modes
Starters can fail for several common reasons, which mechanics should be aware of:
- Worn Brushes and Commutator: Gradual wear reduces electrical contact and motor performance.
- Solenoid or Bendix Wear: Solenoid sticking or a worn drive assembly prevents proper engagement.
- Bearing Wear: Noisy operation or seizing can occur from worn bearings.
- Oil or Water Contamination: Leaks or splash can damage windings and mechanical parts.
- Electrical Issues: Poor battery condition, corroded connectors, or weak charging system reduce starter performance.
Replacement Guidance
High-level steps for replacing the starter. These are general instructions—refer to vehicle-specific service literature for exact procedures and torque values.
- Disconnect the negative battery terminal before starting work to avoid short circuits.
- Locate the starter on the engine bell housing or lower engine flank; accessibility varies by model.
- Label and disconnect electrical connections (main battery cable and control wire) and remove mounting bolts while supporting the starter.
- Inspect the flywheel ring gear for damaged teeth and check surrounding wiring and earth straps.
- Fit the replacement starter, tighten mounting bolts to the manufacturer’s specification, reconnect electrical connections, and reattach the battery.
- After installation, verify cranking speed and listen for abnormal noises. Check charging system voltage and battery condition if slow cranking persists.
Maintenance Tips
- Regularly inspect battery condition and terminal cleanliness—poor battery health is a leading cause of starter issues.
- Avoid repeated short trips where the starter is used frequently without allowing the charging system to recharge the battery.
- Check for oil leaks from engine seals that could contaminate the starter housing; repair leaks promptly.
Technical Information
- Manufacturer: Bosch
- Model: Citroën / Peugeot (see compatibility list)
- Product Codes: 0001112041, 1112041
- Additional Numbers: 9647982880, 5802M9, 5802EP
Installation Recommendations
For safe and reliable installation follow workshop best practices: always disconnect the battery before removal, clean and inspect electrical connections, and check the condition of the flywheel ring gear and starter mounting face. If access is tight, support the starter during removal to prevent dropped fasteners. After fitting, confirm correct engine cranking and monitor for any abnormal noises or excessive current draw.
Why This Part Often Fails
Failure is most often caused by electrical wear (brushes and commutator), solenoid or Bendix wear, contamination from oil/water, or stress from a weak battery/charging system. Addressing battery and charging faults early will extend the life of the replacement starter.
