Description
Third rear brake light for Peugeot 307 vehicles.
High-mount third brake light (center high-mount stop lamp) suitable for Peugeot 307. This unit restores proper brake light signaling at the rear center of the vehicle, improving visibility and meeting safety requirements. Commonly searched under the OEM code 6350P5, it is a practical replacement for workshop professionals and experienced DIY mechanics looking for a direct-fit lighting solution.
Features And Benefits
– Direct-fit replacement for the Peugeot 307 third brake light, designed to match original mounting points and connectors where applicable.
– Restores brake light visibility to ensure compliant braking signal to vehicles behind.
– Ideal for use in repair shops and by motorists performing their own maintenance; frequently located by product code 6350P5.
Compatibility
Fits Peugeot 307 models (Phase 1 and Phase 2). Compatibility depends on the tailgate/bootlid variant and pre-installed lamp holder. Recommended for hatchback and estate versions when the original third brake light uses the same mounting and connector layout.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 307
- Product Codes: 6350P5
- Additional Numbers: Not available / No further cross-reference provided
Installation Recommendations
1) Prepare Tools: Basic trim tools, screwdriver or Torx set depending on fasteners, and a small ratchet set if required.
2) Safety: Disconnect the negative battery terminal before starting work to avoid short circuits while handling electrical connectors.
3) Access: Remove the interior trim panel or access cover on the tailgate to reach the third brake light assembly.
4) Removal: Disconnect the electrical connector, remove retaining screws or clips, and carefully detach the lamp from the tailgate to avoid damaging the lens or paint.
5) Installation: Fit the replacement lamp into the mounting location, secure fasteners to the correct tightness, reconnect the electrical plug and reassemble interior trim. Verify sealing surfaces are clean to prevent water ingress.
6) Test: With the vehicle battery reconnected, test the brake light function (apply brake pedal or have an assistant activate the brake) to confirm correct operation before finishing.
Why This Part Most Commonly Fails
– Water Ingress: Moisture entering the lamp housing causes corrosion of contacts and bulb/LED failure.
– Bulb Or LED Element Failure: Burnt-out bulbs or failed LED modules interrupt the brake signal.
– Connector Corrosion Or Wiring Damage: Corroded pins or damaged wiring can cause intermittent or permanent failure.
– Physical Damage: Impact or stress to the tailgate can crack the lens or dislodge mounting tabs, leading to malfunction or leaks.
Replacing the third brake light is a cost-effective safety repair. Ensure connectors and sealing surfaces are clean and undamaged during installation to maximize service life.
