Description
Seat Belt for Citroën C8 and Peugeot 807. Third-row seat, suitable for both left and right positions.
High-quality replacement seat belt designed for the third row of Citroën C8 and Peugeot 807 vehicles. This unit is intended for professional workshops and experienced DIY mechanics who require a reliable, direct-fit solution for left- or right-side third-row seating. The belt is commonly referenced by the original product codes listed below, making it easy to locate in parts catalogs and order systems.
Technical Information
- Manufacturer: Stellantis (Citroën/Peugeot)
- Model: Citroën C8; Peugeot 807 — Third-Row Left/Right
- Product Codes: 14844310XX, 14005557XX
- Additional Numbers: 8974RK
Fitment And Function
This assembly fits the third-row seating positions on Citroën C8 and Peugeot 807 models. It provides the primary occupant restraint for rear passengers and is designed to lock under sudden deceleration to restrain forward movement. Typical third-row belts for these MPVs are lap-and-shoulder (three-point) systems with a retractor mechanism to maintain appropriate webbing tension during normal use.
Installation Recommendations
- Remove interior trim panels to access mounting points; ensure correct routing of the belt webbing through trim guides.
- Unbolt the original assembly from its anchor points and fit the replacement in the same orientation. Use mounting hardware specified by the manufacturer and tighten to factory torque values.
- If The Vehicle Is Equipped With Pyrotechnic Pretensioners Or SRS Components, Disconnect The Battery And Follow The Manufacturer’s Safety Procedures Before Work — Treat The System As An SRS Component.
- Inspect Anchor Points, Bolts And Surrounding Structure For Damage Or Corrosion; Replace Any Compromised Fasteners.
- After Installation, Check Belt Retraction And Locking Behavior: The Webbing Should Run Smoothly And Lock Under A Sharp Pull.
- Follow The Vehicle Manufacturer’s Instructions For Final Checks And Any Required Adjustments.
Most Common Failure Reasons
- Wear And Abrasion Of Webbing Caused By Frequent Use Or Contact With Sharp Edges.
- Contamination And Dirt In The Retractor Mechanism Leading To Sticking Or Slow Retraction.
- Corroded Or Loose Mounting Points That Compromise Belt Performance.
- Pretensioner Activation During A Collision, Rendering The Belt Nonfunctional And Requiring Replacement.
- Mechanical Failure Of The Locking Mechanism Due To Age Or Internal Component Degradation.
Why Choose This Part
Using a correctly coded replacement belt that matches the original product numbers ensures correct fitment, reliable function and straightforward installation. For workshops and skilled hobbyists, this part reduces vehicle downtime and restores occupant restraint performance in the third row.
Advice For Professionals
Always Verify Fitment By Cross-Referencing The Product Codes Shown Above With Your Parts Catalog. Replace Any Mounting Hardware If Recommended By The Manufacturer And Perform A Full Functional Check After Installation.
