Description
Throttle body for 1.0 1KR engines of Citroën C1 and Peugeot 107. Throttle body housing. Hoses are not included.
The replacement throttle body is a direct-fit solution for the 1.0 1KR petrol engines used in Citroën C1 and Peugeot 107. Designed to restore correct air intake control, this unit improves idle stability, throttle response and overall drivability when the original part is degraded by contamination or electrical wear. Commonly searched under the OEM numbers listed below, this part is suitable for professional workshops and experienced DIY mechanics who perform routine engine maintenance and part replacements.
Compatibility And Application
Fits: Citroën C1 and Peugeot 107 with 1.0 1KR petrol engine. Suitable as a direct replacement for vehicles originally equipped with the listed product numbers. Verify engine type (1KR) before ordering to ensure correct fitment.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Citroën C1, Peugeot 107
- Product Codes: 0280750192, 22030-0Q010, 22030-0Q010-A
- Other Numbers: 163617, 163645, 280750192
Function And Typical Symptoms
The throttle body controls the amount of air entering the engine via a butterfly valve and an integrated position sensor/actuator in electronic throttle systems. Faulty or dirty throttle bodies typically cause rough idle, jerky acceleration, reduced engine performance, increased fuel consumption, and sometimes a check engine light related to throttle position or air intake faults.
Why This Part Fails Most Often
Most common causes of failure are carbon and oil deposits that accumulate on the butterfly and bore, causing sticking or incorrect position feedback. Electrical wear of the throttle position sensor or actuator, wiring and connector corrosion, and vacuum leaks at the gasket/sealing surface also lead to malfunction. Normal wear and contamination over time—especially in urban driving with frequent idling—are common contributors.
Replacement And Installation
Recommended For: Professional technicians and experienced DIY mechanics. General replacement steps:
- Disconnect the battery before starting work to avoid electrical damage or fault codes.
- Remove intake ducting and any obstructing hoses or brackets to access the throttle body.
- Unplug the electrical connector and detach vacuum/hoses (note: hoses are not included with the part).
- Remove mounting bolts, replace the throttle body and use a new gasket/seal if applicable.
- Reconnect hoses and electrical connector. Reinstall intake ducting and reconnect the battery.
- After installation, follow the manufacturer’s recommended idle relearn or adaptation procedure; some vehicles may require a basic adaptation cycle to restore optimal idle and throttle response.
Installation Recommendations
- Always Use A New Gasket Or Seal When Replacing The Throttle Body To Prevent Vacuum Leaks.
- Inspect And Clean The Intake Ducting And Hoses; Replace Any Brittle Or Damaged Hoses.
- Check Electrical Connectors For Corrosion And Secure Proper Contact.
- If The Original Throttle Body Was Contaminated, Clean The Intake And MAF (If Equipped) To Prevent Recurrence.
- Perform Throttle Adaptation/Idle Relearn As Required By Vehicle Procedures.
Why Choose This Part
This throttle body provides an economical and reliable replacement for worn or faulty OEM units on the 1.0 1KR engine. With correct installation and attention to sealing and electrical connections, it restores proper air control and drivability. The listing includes multiple OEM numbers to help you find the exact match quickly when searching by part code.
Note: Hoses Are Not Included With The Throttle Body Unit.
