Description
Center Rear Seat Belt For Peugeot 307 And 308 Kombi / SW
Product Description
High-quality centre rear three-point seat belt designed for Peugeot 307 and 308 Estate (Kombi/SW) models. This part restores safety and restraint for the centre rear passenger and is supplied with the core mounting points required for direct replacement. Commonly sought under the OEM references shown below, it is an essential safety item for workshops and DIY mechanics working on Peugeot passenger cars.
Function And Benefits
The centre rear seat belt is a three-point restraint system that secures the middle rear passenger by distributing crash forces across the pelvis and shoulder. A correctly functioning belt reduces the risk of injury in an impact and keeps occupants in the correct seating position. Benefits include straightforward installation on compatible models, restored safety compliance, and peace of mind for vehicle occupants.
Fitment / Compatibility
Intended for Peugeot 307 and Peugeot 308 Estate (Kombi / SW) rear centre seating positions. Often referenced in parts searches by the product codes listed below (use these codes when searching in parts catalogs or service software).
Technical Information
- Manufacturer: Stellantis (Peugeot)
- Model: Peugeot 307, Peugeot 308 (Estate / Kombi / SW)
- Product Codes: 96589932XX, 8974QK, 8975GY
- Other Numbers: 96589932 XX (variant references seen in parts lists)
Installation Recommendations
Replacement should be performed by a competent technician or an experienced DIYer who follows manufacturer procedures. Typical replacement steps:
- Park on level ground, engage parking brake and remove ignition key.
- Disconnect the vehicle battery and wait the manufacturer-recommended time to disable SRS systems before working near pretensioners or airbag wiring.
- Remove the rear trim panels and seat back upholstery to access the belt retractor and anchor bolts.
- Unbolt the lower anchor and upper mounting points, and carefully unplug any electrical connector if the belt is fitted with a pretensioner.
- Fit the replacement belt, route the webbing correctly, hand-tighten fasteners, then torque to manufacturer specifications.
- Refit trim, reconnect the battery, and perform a visual check of operation and webbing run. If the vehicle has fault codes after installation, clear and re-scan with appropriate diagnostic equipment.
Why This Part Fails
Seat belts typically fail or require replacement for the following reasons:
- Wear and Tear: Fraying, abrasion or cuts to the webbing from long-term use or contact with sharp objects.
- Contamination And Jamming: Dirt, debris or corrosion can cause the retractor to stick or the belt to retract poorly.
- Pretensioner Deployment: Involved in collisions, pretensioners activate and permanently change the belt assembly, requiring replacement.
- Mechanical Damage: Broken anchor bolts, damaged retractors or faulty buckles after impacts or incorrect handling.
Practical Tips
Inspect seat belt webbing regularly for cuts or heavy wear and check that the retractor locks under a sharp pull. Replace immediately if webbing is damaged, if the retractor does not operate smoothly, or after any deployment of the pretensioner. Use OEM or equivalent quality parts and follow torque and safety instructions to ensure correct performance.
Purchase Information
This centre rear seat belt is listed under the common OEM references above—searching by these codes (96589932XX, 8974QK, 8975GY) will help you quickly find the correct replacement. Ideal for professional workshops and competent DIY mechanics performing safety-critical repairs on Peugeot 307 and 308 Estate models.
