Description
Electric passenger seat control for CITROËN C5 first series
Reliable replacement electric seat control for the passenger seat of the Citroën C5 (first generation). This unit operates the electric adjustment functions of the front passenger seat, restoring smooth movement of fore/aft travel, height adjustment and backrest inclination where applicable. Supplied under Stellantis/Citroën part references, it is commonly searched by codes such as 8914AK and 6554J3 — enter these numbers into your parts list to find a fast match.
Function And Fitment
This control module/switch assembly controls the passenger seat’s electric adjustment motors. On the Citroën C5 first series it typically manages longitudinal movement, seat height and backrest angle. Fitment is intended for Citroën C5 first generation vehicles and for other Stellantis vehicles that share the same OEM part numbers listed below. Always confirm fitment by comparing product codes.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Citroën C5 I (First Generation)
- Product Codes: 8914AK, 6554J3, 8914EH, 8914EG
- Other Numbers: 8914EG NFP
Installation Recommendations
Recommended for experienced mechanics or confident DIY enthusiasts. Typical installation steps:
- Disconnect the negative battery terminal before starting to avoid short circuits and prevent airbag system errors.
- Remove seat trim panels and access the switch mounting — trim clips and Torx/Phillips screws are commonly used.
- Unplug the electrical connector and note connector orientation or locking tab position to ensure correct reassembly.
- Unbolt or release the switch from the seat frame, replace with the new unit and reconnect the wiring harness.
- Reinstall trim, reconnect battery and cycle the seat through its functions to verify operation.
Required Tools: Torx/Phillips drivers, trim removal tools, basic socket set. Estimated Time: 30–60 minutes depending on experience and seat trim complexity.
Most Common Failure Reasons
- Wear Of Electrical Contacts: Frequent switching and dirt can cause intermittent contacts or loss of function.
- Moisture Ingress And Corrosion: Water or humidity reaching connectors leads to poor contact or corrosion.
- Broken Plastic Actuators Or Buttons: Repeated use can break the mechanical parts of the switch housing.
- Wiring Harness Damage Or Connector Faults: Chafing, rodent damage or loose pins can interrupt signals to the motors.
- Motor Or Fuse Issues: In some cases a failed seat motor or blown fuse may be the root cause rather than the control switch itself.
Choose this part when you need a direct replacement identified by OEM codes 8914AK or 6554J3. Installing a correct-matching control restores reliable seat adjustment and improves occupant comfort. Add to cart now to replace faulty controls quickly and get the passenger seat functioning as intended.
