Description
Set Of SIEMENS VDO Continental Injectors For 1.6 E-HDI EURO5 Engines. From A Crashed Vehicle With Verified Mileage Of 88,000 Km.
High-Quality Set Of Four Injectors Designed For 1.6 E-HDi EURO5 Engines, Supplied From A Vehicle Salvage With Documented 88,000 Km. This Injector Set Is Original Equipment Design Compatible With Stellantis Citroën And Peugeot Applications And Is Often Searched By Part Numbers Listed Below. Ideal For Professional Mechanics And Experienced DIY Enthusiasts Who Need A Direct Replacement For Faulty Or Leaking Injectors.
Technical Information
- Manufacturer: Siemens VDO / Continental
- Model: 1.6 E-HDi (EURO5)
- Product Codes: 9674973080, 9802448680, A2C59513556
- Other Numbers: 1980ER, 1980ET
Fitment And Compatible Models
Designed For Vehicles Equipped With 1.6 E-HDi EURO5 Diesel Engines. Typical Compatible Models Include:
- Citroën C4
- Citroën C4 Picasso
- Peugeot 3008 I
- Peugeot 308
- Peugeot 5008 I
- Peugeot 508
Function Overview
Injectors Meter And Atomize Fuel Into The Combustion Chamber At High Pressure As Part Of The Common-Rail Fuel System. Accurate Fuel Delivery Is Essential For Smooth Idling, Fuel Economy, Emissions Control, And Engine Performance. These Units Are Intended To Work With The Engine Control Unit And High-Pressure Fuel Rail To Deliver Precise Injection Timing And Quantity.
Signs Of Faulty Injectors
- Rough Idle Or Misfires
- Increased Fuel Consumption
- Hard Starting Or Loss Of Power
- Diesel Odor Or Visible Fuel Leaks Around Injector Seals
- Smoke From Exhaust Under Load Or Acceleration
Installation Recommendations
- Depressurize The Fuel System Before Starting Work And Follow Manufacturer Safety Procedures.
- Disconnect The Battery To Avoid Electrical Short Circuits During Service.
- Clean The Area Around Each Injector To Prevent Dirt Entering The Cylinder When Removing The Injector.
- Mark Injector Positions If Reinstalling Original Parts; Replace Copper Crush Washers And Any Seals Or O-Rings With New Items.
- Tighten Injector Hold-Downs And Fuel-Rail Fasteners To Manufacturer Torque Specifications; If Uncertain, Consult Repair Manual.
- After Installation, Prime The Fuel System And Check For Leaks. Perform A Controlled Start-Up And Verify Engine Running Conditions.
- When In Doubt, Use Proper Diagnostic Equipment To Verify Injector Electrical Resistance And Pulse Signal From The ECU.
Why Injectors Fail Most Often
Common Causes Of Injector Failure Include Fuel Contamination (Water, Dirt, And Carbon), Poor Fuel Quality, Clogged Nozzles, Wear Of Moving Parts, And Electrical Failures Of The Injector Solenoid. Mechanical Damage Can Also Occur In Collision Scenarios; This Set Comes From A Crashed Vehicle But Shows Documented Mileage Of 88,000 Km, Which May Indicate Remaining Service Life Depending On Previous Maintenance And Fuel Quality.
Notes For Professional Use
These Injectors Are Supplied As Used Units From A Salvage Vehicle. They Are Suitable For Replacement Projects Where Original Equipment Compatibility By Part Number Is Required. Many Customers Search By The Part Numbers Provided Above When Looking For Direct Replacements.
