Description
A/C compressor bracket for Citroën and Peugeot vehicles with 1.1i, 1.4i and 1.6i engines.
This A/C compressor bracket (OEM Reference: 9656881780 / 6453JT) provides a direct-fit mounting solution for air conditioning compressors on selected Citroën and Peugeot petrol engines. Manufactured to meet OEM geometry and load requirements, the bracket ensures correct alignment of the compressor with accessory drive components, helping to maintain belt tension and prevent premature wear. Ideal for professional garages and DIY mechanics who require a reliable replacement part identified by product codes.
Compatible Models
Citroën C3; Citroën C3 Pluriel; Citroën C4; Peugeot 206; Peugeot 206+; Peugeot 207; Peugeot 307. Compatibility applies to vehicles equipped with 1.1i, 1.4i and 1.6i engines where this bracket is specified.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Citroën C3, Citroën C3 Pluriel, Citroën C4, Peugeot 206, Peugeot 206+, Peugeot 207, Peugeot 307
- Product Codes: 9656881780, 6453JT
- Other Numbers: 6453.JT, 6453.JT (alternative notation)
Installation Recommendations
- Prepare The Vehicle: Park on a level surface, engage the handbrake and follow standard safety procedures for working under the bonnet.
- Relieve Drive System Tension: Loosen and remove the accessory drive belt following the manufacturer procedure to avoid damaging the belt or pulleys.
- Support The Compressor: Securely support the A/C compressor to avoid stress on refrigerant lines. Do not disconnect refrigerant lines unless qualified and certified to work on the A/C system.
- Remove Old Bracket: Unbolt the existing bracket, noting the position of spacers and washers. Inspect surrounding mounting points for corrosion or damage.
- Fit New Bracket: Install the replacement bracket, using new bolts if original fasteners show wear. Tighten fasteners to the manufacturer torque specifications—refer to the factory repair manual for exact values.
- Reassemble: Refit the compressor, restore belt tension and check pulley alignment. Start the engine and verify accessory drive operation without unusual noise or vibration.
- Final Checks: Inspect for clearance to hoses and wiring; verify that A/C compressor engagement is smooth. If any A/C system components were disconnected, have the system checked and serviced by a certified technician.
Most Common Failure Causes
- Corrosion And Rust: Prolonged exposure to road salt and moisture can weaken the bracket and mounting points.
- Mechanical Impact: Front-end impacts or engine bay collisions can bend or crack the bracket.
- Vibration And Fatigue: Excessive vibration from worn engine mounts or misaligned pulleys can cause fatigue fractures over time.
- Incorrect Installation: Improper torqueing or reuse of damaged fasteners can lead to loosening and eventual failure.
Why Choose This Part: This bracket is supplied to match OEM fit and mounting geometry, making it a straightforward replacement for technicians familiar with Citroën and Peugeot accessory drive assemblies. Use the part numbers above when searching or ordering to ensure a fast match.
Order now to restore secure A/C compressor mounting and prevent belt misalignment or accessory-drive issues. If in doubt about removal or reinstallation, consult the vehicle service manual or a qualified technician.
