Description
Filler neck housing for the fuel tank for Peugeot 207. Colored cover may be purchased separately.
Product Overview
This genuine-style filler neck housing is designed for the Peugeot 207 and provides a robust, direct-fit replacement for a damaged or worn fuel filler opening. The part restores correct alignment and sealing of the fuel cap area, helping to prevent fuel odors, ingress of dirt and water, and problems with the fuel cap locking mechanism. Ideal for professional workshops and DIY mechanics who require a reliable OE-matching component. Frequently searched under the code 151896.
Key Benefits
- Direct-fit replacement for easy installation and correct sealing.
- Durable construction resistant to everyday exposure to fuel and weather.
- Compatible with optional coloured covers for a factory look.
- Commonly referenced by part code 151896 for fast lookup.
Fitment
Fits Peugeot 207 models. Typically compatible with standard body variants; check vehicle’s existing part appearance and mounting points before ordering. This part is aimed at fitment to vehicles that use the same filler neck housing design as the original equipment.
Replacement Procedure
Basic steps for replacing the filler neck housing (general guidance):
- Open fuel flap and remove the fuel cap.
- Remove any trim screws or clips securing the filler surround; depending on model access may require opening from inside the wheel arch or removing a small inner liner panel.
- Disconnect any retaining clips, vent hoses or cap lock rods from the housing. Take care with plastic clips to avoid breakage.
- Detach the housing from the body, remove the old seal and clean the mounting face to remove dirt and corrosion.
- Fit the new housing with a new sealing gasket if supplied or recommended, reconnect hoses and clips, then refit trim fasteners and the fuel cap.
- Check for correct closure and sealing; ensure the fuel cap locks and the flap aligns properly.
For intensive corrosion or difficult access, removal of nearby trim or partial bumper/wheel arch lining may be required. Use appropriate hand tools and follow safety rules for working around the fuel system (no open flames, avoid sparks, work in a well-ventilated area).
Installation Recommendations
- Use new seals or gaskets when refitting to ensure proper sealing and to prevent fuel odors.
- Avoid over-tightening plastic screws and clips; replace any brittle fasteners to ensure secure fitment.
- Clean mounting surfaces and treat minor corrosion before installation to prolong service life.
- If unsure about access or required disassembly, consult a professional workshop to prevent damage to adjacent bodywork or fuel system components.
Most Common Failure Causes
- Corrosion From Road Salt And Moisture: Metal or poorly sealed areas can corrode, breaking the seal and allowing water or debris into the filler area.
- Impact Damage: Backing into a pump or accidental knocks can crack or deform the housing or its mounting points.
- Plastic Embrittlement: Age, UV exposure and temperature cycles can make plastic components brittle, leading to broken clips or cracked surrounds.
- Worn Or Damaged Seal: A degraded seal causes fuel odors, difficulty with cap closure or intermittent warning lights related to evaporative system faults.
Technical Information
- Manufacturer: Peugeot (Stellantis)
- Model: Peugeot 207
- Product Codes: 151896
- Additional Numbers: 151896
Notes
Colored cover for the filler area is available separately, allowing restoration to the vehicle’s original appearance. This listing is intended for mechanics and experienced DIYers; ensure the part matches the vehicle’s existing mounting points before fitment.
