Description
Product Overview
Right side (passenger side) door mirror for the Peugeot 207 designed to the original PSA specifications. This unit offers electric adjustment, an integrated heating element and a temperature sensor to improve defogging and driver visibility in cold or wet conditions. The housing is finished in EZRC Grey Aluminium paint to match factory trim.
Compatibility And Fitment
Direct fit for Peugeot 207 models. Supplied as a right side front door mirror. Before ordering, verify the OEM product codes 96806501XT and 8149ZH against the vehicle identification to ensure correct fit for specific model years and trim levels.
Function And Typical Faults
The mirror provides mechanical angle adjustment via an electric motor, heating for rapid glass demisting and a temperature sensor used by some vehicle control systems. Common failure modes include motor wear or gear damage (loss of adjustment), heater element open circuit (no demist), broken glass or damaged housing after impacts, and corrosion or wiring faults in the electrical connector. Water ingress and impact damage are the most frequent causes of premature failure.
Replacement And Installation Notes
Replacement is straightforward for an experienced mechanic or competent DIYer but requires careful handling of trim and connectors. Typical steps:
- Remove the inner door trim or the small triangular trim panel covering the mirror mounting area.
- Disconnect the mirror electrical connector and any speaker/tweeter connectors if applicable.
- Support the mirror from outside, then remove the retaining nuts or bolts securing the mirror to the door.
- Withdraw the old mirror, fit the new unit, tighten the fasteners to secure the assembly and reconnect the wiring harness.
- Test electric adjustment and heating function before reassembling the door trim. Handle panel clips carefully to avoid breakage.
Common Maintenance Tips
Check connector pins and seals for corrosion and ensure the door sealing surfaces are intact to reduce water ingress. If a mirror motor operates slowly, clean and secure the connector and check vehicle fuses and switches before replacing the entire unit.
