High-quality steering wheel control switches designed for Citroën C1, Peugeot 107 and Toyota Aygo models from 2012 to 2014. These switches restore audio, phone and cruise-control ergonomics on the steering wheel, offering a direct replacement for worn or damaged button modules. Often searched by product codes 6239SA and B000612880, this part is suited to both professional workshops and DIY mechanics who want a reliable, vehicle-specific solution.

Technical Information

• Manufacturer: Stellantis (Citroën/Peugeot)
• Model: Citroën C1; Peugeot 107; Toyota Aygo
• Product Codes: 6239SA, B000612880
• Additional Numbers: Production Years 2012–2014

Compatibility

Fits Citroën C1, Peugeot 107 and Toyota Aygo models built between 2012 and 2014. Check the part code (6239SA / B000612880) when searching to ensure proper match for the steering wheel trim and connector layout.

Function And Common Failures

Steering wheel controls provide user input for audio systems, hands-free phone operation and, where fitted, cruise-control commands. The switches transmit low-voltage signals through the steering column wiring to the vehicle’s radio or body control unit.

Typical causes of failure:

• Mechanical Wear: Buttons and plastic actuators wear or break after years of use.
• Contact Oxidation: Electrical contacts can corrode or lose conductivity, causing intermittent function.
• Moisture Ingress: Spills or high humidity can damage switch contacts.
• Connector Or Cable Damage: Wiring fatigue inside the steering column due to frequent movement.

Replacement Frequency

There is no fixed lifespan; failures typically occur on higher-mileage cars or after physical damage. In workshops, these switches are commonly replaced between 80,000–200,000 km depending on usage and environment.

Installation Recommendations

• Always Disconnect The Battery Before Starting Work And Wait The Manufacturer-Specified Time To Prevent Airbag Deployment.
• Remove Steering Wheel Trim And, If Required, The Airbag Module Following Manufacturer Procedures.
• Carefully Release The Old Switch Unit From Its Mounts, Disconnect The Electrical Connector And Compare The Connector Pinout And Mounting Points With The Replacement.
• Install The New Switch, Reconnect The Connector Securely, Reassemble The Trim And Airbag, Then Reconnect The Battery.
• If Any Steering Angle Or Electronic Settings Are Affected After Replacement, Follow The Vehicle Manufacturer’s Calibration Procedure.
• Recommended Tools: Torx/Hex Drivers, Trim Tools, Multimeter For Continuity Check.

Why Choose This Part

Designed To Match The Original Fitment And Wiring Layout For The Specified Models, This Steering Wheel Control Module Restores Full Functionality Without Extensive Modifications. The part codes 6239SA and B000612880 help you find the correct item quickly in catalogs and search engines.

Notes For Mechanics And DIYers

When replacing steering wheel controls, pay special attention to connector integrity and the condition of surrounding trim. If the airbag was removed, verify torque settings and clip engagement during reassembly. Use a multimeter to check switch continuity before full reassembly to avoid repeated disassembly.