Part description

This used car part is intended as a right rear lid lamp for a Peugeot 3008 I. It is a part of the bodywork and lighting, which is especially sought after when the rear part of the car is damaged or when a broken or non-functioning lamp is replaced. Thanks to the designation 9805511280, it is also suitable for a quick search by product number.

The headlight is located on the side behind the passenger and is intended for the hinged door. For auto mechanics and home repairers, it is important to compare the shape, fit, connector and part number with the existing piece.

Technical information

• Manufacturer: Stellantis Citroën Peugeot
• Model: Peugeot 3008 I
• Other numbers: 9805511280

Product codes

• Product codes: 9805511280
• Models: Peugeot 3008 I

Installation recommendations

Generally/typically for this type of part, the exact procedure for replacing a tail lamp in a liftgate may vary depending on the specific model of the car. Before actual assembly, it is always advisable to carefully compare the new and original part.

1) Before assembly

• Check if the side of the part matches – the right, i.e. the side behind the passenger.
• Compare part number 9805511280 with the old headlight.
• Check the condition of the cover, attachment points, connector and seating surfaces.
• Make sure the part is not cracked and does not have damaged internal parts or signs of leaks.

2) Necessary tools and materials

• Basic set of hand tools
• Plastic pry bar for panel removal
• Clean cloth or tea towel
• Preparation for cleaning contacts, if needed
• Work gloves and suitable lighting

3) Step-by-step assembly procedure

1. Turn off the ignition and secure the vehicle against movement.
2. Open the hinged door and access the interior where the lamp is attached.
3. If necessary, carefully remove the inner cover or trim that prevents access to the part attachment.
4. Disconnect the electrical connector from the original headlight.
5. Unfasten the fasteners of the old lamp and carefully remove the part so as not to damage the surrounding paint or plastics.
6. Compare the old and new part – especially the shape, fit, connector and seating surfaces.
7. Clean the seating area and check that there are no dirt or damaged parts of the original mounting.
8. Connect the connector to the new headlight.
9. Place the lamp in the correct position without force and check its alignment with the surrounding parts.
10. Tighten the fastening sufficiently so that the part is firmly seated and at the same time does not damage the plastic parts.
11. Reinstall any trim or cover.
12. When finished, turn on the lights and verify the correct operation of the lamp.
• 4) Post-assembly checks and function verification
  • Check that the headlight is firmly held and does not move anywhere.
  • Verify correct alignment with lid and surrounding bodywork.
  • Test the lighting function according to the car’s equipment.
  • After the first rides, re-check the fastening and any signs of moisture ingress.

  5) The most common assembly mistakes + how to avoid them

  • Swapping the left and right side – always check before fitting that it is the right side behind the passenger.
  • Not matching the part number – always compare the 9805511280 marking with the old part.
  • Rough handling during disassembly – use appropriate tools and do not exert unnecessary force.
  • Bad seat of the lamp – check the position and fit of the part before tightening.
  • Neglected cleaning of contacts and contact surfaces – dirt can cause problems with attachment and functionality.

  Reasons why the part is damaged

  • Damage during a parking manoeuvre or minor collision of the rear of the car
  • Cracking of the cover due to impact
  • Intrusion of moisture into the lamp and subsequent deterioration of function
  • Damage to handles during unprofessional disassembly
  • Normal wear and tear and material aging
  ]]>