Overview

This right rear tailgate reflector is designed for Citroën C3 II (A51) models produced between 2009 and 2016. It restores the original rear visibility and road safety marking on the tailgate, ensuring the vehicle remains compliant with reflector and visibility requirements. Ideal for professional workshops and DIY mechanics, the part is commonly searched by OE numbers and aftermarket references.

Fitment And Function

Fitment: Citroën C3 II (A51) 2009–2016 (Right Side, Tailgate). Confirm compatibility by matching the vehicle model and the part numbers listed below.

Function: The reflector provides passive rear visibility by reflecting light from other vehicles. It does not contain electrical components. Properly positioned reflectors improve safety during night-time and low-light conditions and are integral to the rear lighting cluster appearance.

Replacement Procedure

The replacement is straightforward and suitable for a competent DIYer or professional mechanic. Typical steps:

• Open the tailgate and remove the inner trim panel to access the reflector mounting area (use plastic trim tools to avoid damage).
• Locate and release any retaining clips or fasteners holding the reflector; some versions are secured with screws or plastic rivets.
• Carefully withdraw the old reflector from the tailgate recess and clean the mounting surface of dirt and corrosion.
• Install the new reflector, ensuring clips or fasteners engage securely and the part sits flush with the bodywork.
• Reinstall the inner trim and verify correct fitment and alignment. No electrical reconnection is required for passive reflectors.

Technical Information

• Manufacturer: Stellantis (Citroën)
• Model: Citroën C3 II (A51) 2009-2016
• Product Codes: 9685225480
• Additional Numbers: 89090140, 6351JC

Installation Recommendations

Use appropriate trim tools to avoid damaging the tailgate trim and paint. If fasteners are corroded or damaged, replace them with equivalent clips or screws. After installation, check that the reflector is seated evenly and that gaps to the bodywork are consistent to prevent water ingress. For repairs after collisions, inspect surrounding mounting points and the tailgate structure for deformation before fitting the new reflector.

Most Common Failure Reasons

Reflectors are passive and rarely ‘fail’ electrically, but they commonly require replacement due to:

• Impact Damage: Rear parking collisions or knocks to the tailgate that crack or break the reflector.
• Physical Wear: Scratches, abrasions, or loss of reflective surface from road debris and repeated cleaning.
• Mounting Clip Failure: Plastic clips or tabs can become brittle and break with age or during removal.
• Moisture Ingress: Seals or poor fitment allowing water to collect behind the reflector, causing fogging or reduced reflectivity.

Replacing a damaged reflector restores both safety and the original appearance of the rear of the vehicle. For workshops, stocking the common OE numbers listed above increases service speed for Citroën C3 II repairs.