Commonly searched by part numbers, this Left Light also corresponds to 89398407 and 6350T2. It’s essential for maintaining your vehicle’s lighting system and should be replaced if damaged or malfunctioning. Regular checks are advised, especially if you notice dimming or flickering, as these are signs that it may need replacement. Routine replacement of lights is crucial to ensure that you’re visible to other drivers and pedestrians, reducing the likelihood of accidents.

Technical Information:

• Manufacturer: PSA Citroën Peugeot
• Model: Citroën Xsara Picasso
• Part Numbers: 9650005880
• Additional Numbers: 89398407, 6350T2

This rear left tail light assembly is a direct-fit replacement for Citroën Xsara Picasso models listed from 2005. It carries the original equipment reference numbers and is suitable for professional workshops and skilled DIY enthusiasts searching by OE codes such as 6350T2, 9650005880 or 89398407. The unit restores the vehicle’s rear lighting functions and exterior appearance while maintaining correct fitment and alignment on the tailgate/quarter panel mounting points.

Technical Information

• Manufacturer: Stellantis / Citroën
• Model: Citroën Xsara Picasso (From 2005)
• Product Codes: 6350T2
• Additional Numbers: 9650005880, 89398407

Compatibility And Fitment

Fits Left Rear Position On Citroën Xsara Picasso Vehicles Produced From 2005. Confirm fitment by matching the OE numbers 6350T2 / 9650005880 / 89398407 with the original lamp on the vehicle. Designed to align with factory mounting points and connector layout for a straightforward installation.

Installation Recommendations

• Work In A Clean, Well-Lit Area: Keep screws and clips organized to avoid losing original fasteners.
• Disconnect Battery: Before starting any electrical work, disconnect the negative terminal to prevent short circuits and accidental activation.
• Access The Lamp: Open tailgate and remove interior trim or access panel to reach mounting screws and electrical connector.
• Remove Mounting Fasteners: Unscrew bolts/clips securing the assembly, carefully pull the lamp outwards and unplug the electrical connector.
• Install New Unit: Connect the electrical plug, position the lamp in the mounting recess, and tighten screws to manufacturer torque where available. Refit interior trim and test all light functions (tail, brake, indicator, fog/reverse as applicable) before finishing.
• Sealing And Alignment: Check the sealing surface for correct contact to prevent water ingress; adjust alignment so the lamp sits flush with body panels.

Most Common Failure Reasons

• Impact Damage: Rear-end collisions or parking knocks commonly crack the lens or break mounting tabs.
• Water Ingress And Corrosion: Damaged seals or cracks allow moisture to enter, causing connector corrosion or internal electrical faults.
• Bulb Or Socket Wear: Repeated bulb changes, vibration and heat cycles can wear sockets or cause poor contacts.
• Connector Problems: Oxidation or loose connectors lead to intermittent operation or complete failure of lighting functions.
• Aging And UV Degradation: Prolonged exposure to sunlight can fade or craze the lens, reducing light output and visual appearance.

Why Choose This Part

Referenced by OE numbers 6350T2 / 9650005880 / 89398407, this tail light is intended for technicians and competent DIYers who need a reliable, correct-fit replacement for Citroën Xsara Picasso models from 2005. Clear labeling with OE codes makes it easy to find the exact part during parts searches and ensures compatibility with factory mounting and connectors.

Final Notes

After installation, always verify all rear lighting functions and, if available, consult the vehicle repair manual for torque values and any model-specific steps. Proper installation restores safety and legal compliance for rear illumination and signaling.