This driver seat airbag is intended for mechanic workshops and competent DIY enthusiasts servicing Peugeot 206 vehicles. The part is commonly searched by OE codes 96498618ZR and 8216P2 and is compatible with standard Peugeot 206 seating assemblies. Use this listing to quickly identify the correct module by part number and to get practical installation and troubleshooting guidance.

Product Overview

The driver seat airbag module is a critical component of the occupant restraint system (SRS). It sits inside the driver’s seat and is designed to deploy in the event of a crash to reduce occupant injury. This module includes the airbag cushion and housing; electrical wiring or seat loom may not be supplied, so verify connector type and length before installation. Suitable for Peugeot 206 applications where OE numbers 96498618ZR or 8216P2 are specified.

How It Works

On detection of a severe impact, the vehicle’s airbag control unit (ACU) triggers the squib in the seat airbag. The squib ignites a gas generator, inflating the cushion to provide a protective barrier between the occupant and hard interior surfaces. After deployment the module must be replaced—deployed airbags cannot be reused.

How To Replace

• Park vehicle on level surface, set parking brake and follow manufacturer safety precautions.
• Disconnect the negative battery terminal and wait the manufacturer-recommended time before working on the SRS system (at least 10 minutes is commonly advised).
• Remove seat trim panels as required to access the airbag module fasteners. In many Peugeot 206 variants the airbag is secured to the seat frame with accessible bolts; retain and inspect fasteners and clips.
• Carefully disconnect the airbag connector(s). Note orientation and locking tabs; damaged connectors must be repaired or replaced.
• Unbolt and remove the old airbag module. Fit the replacement unit ensuring correct alignment and seating of the cushion inside the cover.
• Reconnect the wiring harness, reinstall seat trim and fasteners, and reconnect the battery.
• Use a diagnostic tool to read and clear SRS fault codes. If the airbag lamp remains lit, further diagnosis with a compatible scanner is required.

Installation Recommendations

• Always follow the vehicle manufacturer’s service manual for removal and installation procedures.
• Disconnect the battery and observe the recommended waiting time to avoid accidental deployment.
• Handle the airbag module with the trim side facing away from you and avoid exposure to static or impact.
• Do not reuse a deployed airbag or damaged squib assemblies. Replace any damaged wiring or connectors rather than attempting repairs that do not meet factory standards.
• After replacement, perform a full SRS system scan and clear codes. Confirm lamp extinguishes and run any required initialization procedures per Peugeot service documentation.

Most Common Failure Reasons

• Deployment During A Collision: Airbags are single-use and must be replaced after deployment.
• Connector Or Wiring Damage: Seat movement, corrosion or previous repairs can damage wiring and cause SRS faults.
• Water Or Moisture Ingress: Moisture can corrode contacts and lead to intermittent faults or complete failures.
• Physical Damage To Module Or Trim: Impact or improper removal can damage the cushion or housing.
• Electrical Faults In SRS System: Faulty sensors, ACU issues or poor grounding can prevent correct operation and trigger warning indicators.

Technical Information

• Manufacturer: Stellantis / Peugeot
• Model: Peugeot 206
• Product Codes: 96498618ZR, 8216P2
• Additional Numbers: NFP (as listed)

Note: Cable/wiring may not be included with the module—verify connector type and loom length before purchase. Replacement should be performed or verified with appropriate SRS diagnostic equipment if you are not fully confident in the procedure.