Reliable replacement hazard light switch designed for Peugeot 207 and 206+. Ideal for professional workshops and DIY mechanics who need a direct-fit control for the vehicle’s emergency flashers. This switch restores clear, tactile operation of the hazard lights and is often searched by part numbers 96472122KR, 96472122XT and 6554RQ — include these codes in searches to find the exact match for your car.

Function And Application

The hazard light switch controls the activation of all indicator lamps simultaneously for emergency signalling. It completes the flasher circuit and provides a positive mechanical feedback so the driver can confirm the hazard system is active. Correct operation is essential for road safety and legal compliance when indicating breakdowns or emergency stops.

Technical Information

• Manufacturer: Stellantis (Citroën/Peugeot)
• Model: Peugeot 206+, Peugeot 207
• Product Codes: 96472122KR, 96472122XT, 6554RQ
• Additional Numbers: Commonly referenced under OEM tags 96472122KR / 96472122XT / 6554RQ

Replacement Procedure (Overview)

Designed for straightforward replacement by experienced mechanics and competent DIYers. Typical replacement steps:

1. Disconnect the negative battery terminal before starting work to prevent short circuits and protect vehicle electronics.
2. Remove the relevant dashboard trim panel or center console bezel to access the switch — usually retained by clips or a few screws.
3. Unplug the electrical connector from the rear of the switch. Inspect connector and wiring for corrosion or damage.
4. Release the retaining clips on the switch and pull the unit out. Fit the new switch in the correct orientation until it locks into place.
5. Reconnect the electrical connector, reassemble trim, reconnect the battery, and verify correct operation of the hazard lights and indicator function.

Installation Recommendations

• Always disconnect the battery before removal and follow manufacturer procedures to avoid damage to electronic modules.
• Check the connector pins and wiring harness for corrosion, bent pins, or water ingress before installing the new switch.
• If indicators behave irregularly after replacement, verify flasher relay and earth connections — intermittent grounding issues can mimic a faulty switch.
• Use gentle plastic trim tools to avoid breaking dashboard clips; reuse fasteners unless damaged.

Most Common Failure Reasons

• Wear Of Internal Contacts: Repeated mechanical use causes contact wear or pitting, leading to intermittent or non-functioning hazard activation.
• Mechanical Breakage: Internal springs or plastic parts can fracture from age or rough handling when operating the switch.
• Electrical Corrosion: Moisture ingress or dirty connectors lead to poor contact and unreliable operation.
• Wiring Problems: Damaged or loose wiring and poor ground connections can cause the hazard lights to fail despite a good switch.

Why Buy This Part

If your hazard lights are intermittent, silent, or the switch feels loose or non-clicking, replacing the switch with the correct part number (96472122KR / 96472122XT / 6554RQ) restores reliable emergency signalling. The unit fits directly into the dash of Peugeot 207 and 206+ models and is a cost-effective repair to maintain vehicle safety.