Part description

This used left side airbag is intended for Citroën C3 II A51 cars and corresponds to the design for the driver’s side. It is an important safety element of the interior, which is searched mainly according to the original part numbers. For correct identification, the key codes are 9672465380 and 8216ZQ.

The part is suitable for mechanics and car owners who are looking for a genuine used PSA car part at a reasonable price. For safety components, visual inspection of the condition, intactness of connectors, packaging and fastening points is essential.

Technical information

• Manufacturer: Stellantis Citroën Peugeot
• Model: Citroën C3 II A51
• Other numbers: 9672465380, 8216ZQ

Product codes

• Product codes: 9672465380, 8216ZQ
• Models: Citroën C3 II, Citroën C3 II A51

Installation recommendations

Extreme caution is required with this type of part, as it is part of the vehicle’s safety system. Generally and typically for airbag parts, the exact disassembly and assembly procedure may vary depending on the specific car design and interior equipment.

1) Before assembly

• Check if the product designation of the old part and the new part match.
• Compare the connectors, mounts, part shape and orientation for the correct side.
• Check whether the used airbag shows signs of mechanical damage, deformation, damage to the packaging or damage to the wiring.
• Before any handling, disconnect the battery and wait a reasonable time according to normal service practice.

2) Necessary tools and materials

• Common workshop hand tools
• Interior trim removal kit
• Protective gloves
• Clean workspace for safe storage of the part

3) Step-by-step assembly procedure

1. Secure the vehicle against movement and turn off the ignition.
2. Disconnect the battery and before further work observe the usual safety delay when working with the airbag system.
3. Dismantle the necessary parts of the interior trim so that access to the original part is possible without forced prying.
4. Carefully disconnect the electrical connector of the original airbag.
5. Unfasten the old part and remove it so as not to damage the surrounding parts of the interior.
6. Compare the original and used part by number, shape, fit and connectors.
7. Place the used airbag in place in the appropriate position.
8. Attach the part the same way the original piece was attached.
9. Connect the electrical connector and check that it fits properly without straining the wiring.
10. Reinstall the removed interior trim and double check that nothing is rubbing or pinched anywhere.
11. Connect the battery.
12. Perform a basic system function check according to normal service procedure.
• 4) Post-assembly checks and test drive/function verification
  • Check that all interior parts are properly seated and secure.
  • Check that there are no loose connectors or pinched wires after assembly.
  • Sledujte kontrolky a celkový stav systému po zapnutí zapalování.
  • If any defect appears in the passive safety system, professional diagnostics and assembly inspection are required.

  5) The most common assembly mistakes + how to avoid them

  • Assembly without comparing part numbers – always compare the markings 9672465380 and 8216ZQ with the old part.
  • Handling with the battery connected – always disconnect the power before working on the airbag system.
  • Damage to the connector or wiring – do not disconnect the connectors by force and protect the wiring harness from being pinched.
  • Using a part with visible damage – install the safety part only if it is visually in good condition.

  Reasons why the part is damaged

  • Airbag activation in the event of an accident or impact
  • Damage due to unprofessional disassembly of the interior
  • Disruption of connectors or cabling during handling
  • Moisture, pollution or long-term inappropriate storage
  • Mechanical damage to the part’s attachment or packaging
  ]]>