This genuine replacement driver seat airbag is designed for early Citroën C1 and Peugeot 107 models (first series). It restores occupant restraint functionality after deployment or damage and fits into the seat structure in place of the original module. Ideal for professional workshops and experienced DIY mechanics searching by OE numbers 73920YV010 or 8216FK.

Benefits and Key Features

• Direct fit for compatible First Series Citroën C1 and Peugeot 107 models (up to 2013).
• OE Reference Numbers Included For Fast Search: 73920YV010, 8216FK.
• Designed To Interface With The Vehicle SRS Wiring Harness And Seat Structure.
• Slim design integrated into the seat cushion/backrest for correct deployment geometry.

How Replacement Is Performed

Replacing a seat airbag requires care and basic electrical diagnostic knowledge. Typical replacement steps performed by a professional or experienced DIY mechanic:

• Disconnect The Negative Battery Terminal And Wait At Least 10 Minutes To Allow Capacitors In The SRS System To Discharge.
• Move The Seat To Provide Access, Remove Seat Trim And Covers To Expose The Airbag Module.
• Unbolt The Airbag Module From The Seat Frame Using Appropriate Tools; Carefully Disconnect The SRS Connector.
• Install The New Airbag Module In Reverse Order, Ensuring Connectors Are Fully Seated And Locks Engaged.
• After Reconnection, Use An OBD/Diagnostic Tool To Check SRS Faults And Clear Airbag Codes; Verify System Status.

Installation Recommendations

• Always Disconnect The Battery Before Any Work On The Airbag System And Follow Manufacturer Safety Procedures.
• Do Not Probe, Short Or Tamper With Airbag Connectors; Handle Modules With The Inflatable Side Facing Away From You.
• Use A Suitable Diagnostic Tool To Read/Reset SRS Faults After Replacement. If Airbag Warning Light Persists, Recheck Connections And Wiring.
• Replace Any Fasteners Or Clips That Are Damaged; Ensure The Seat Is Reassembled Exactly As Original To Maintain Deployment Path.
• If The Vehicle Was Involved In A Collision, Inspect Seat Structure And Wiring For Hidden Damage Before Installing The New Module.

Reasons For Most Common Failures

• Deployment During A Collision — Airbags Must Be Replaced After Activation.
• Damage Or Corrosion Of Wiring And Connectors Causing Intermittent Or Permanent Faults.
• Physical Damage To The Seat Or Module From Improper Repairs Or Wear, Affecting Connector Integrity.
• Moisture Ingress Or Seat Cushion Damage Leading To Electrical Faults.
• SRS Control Unit Detecting Anomaly (Wiring, Connector, Or Internal Module Fault) — Requires Diagnostic Troubleshooting.

Technical Information

• Manufacturer: Stellantis (Citroën / Peugeot)
• Model: Citroën C1 (First Series) / Peugeot 107 (First Series) — Up To 2013
• Product Codes: 73920YV010
• Additional Numbers: 8216FK

Notes For Professionals And Enthusiasts

This airbag module is intended as a direct replacement for the specified first-series models. There Is No Standard Service Interval For Airbags — Replace When Deployed, Physically Damaged, Or When The SRS System Reports A Fault. Always Verify System Integrity With Proper Diagnostic Equipment After Installation.