This replacement antenna is designed for Citroën and Peugeot vehicles and corresponds to common OEM references used by Stellantis. Ideal for professional workshops and experienced DIY mechanics, the unit restores reliable radio reception and a factory-fit appearance. Many customers search directly by product number (e.g. 9674768680, 9810547980, 658724) — these codes are included below to help you find the correct part fast.

Features and Function

The antenna assembly provides stable AM/FM radio reception and a secure roof mounting. The assembly typically includes the mast/base, coaxial connection and roof sealing. On some vehicle versions the antenna base is combined with an amplifier module; compatibility depends on the original equipment fitted to the vehicle.

Suitable For

• Citroën C3
• Citroën C3 Picasso
• Citroën C4 Picasso
• Peugeot 308

Technical Information

• Manufacturer: Stellantis (Citroën / Peugeot)
• Model: Antenna / Roof Antenna
• Product Codes: 9674768680, 9810547980, 658724, 6587G4, 6587G3
• Additional Numbers: 6580J0, 6561JT, 6561JS

Installation Recommendations

Recommended tools: Torx/Spline sockets, trim removal tools, adjustable wrench, sealant for roof fittings and dielectric grease for connectors. Typical replacement steps:

• Disconnect the negative battery terminal before starting the job to avoid short circuits.
• Remove interior roof trim or headliner section as required to access the antenna base from inside the vehicle.
• Unscrew the external mast (if fitted) and unbolt the antenna base retaining nut.
• Disconnect the coaxial connector and any power or amplifier plugs carefully to avoid damaging clips or wiring.
• Clean the roof sealing surface, fit the new antenna with new gasket/sealant as required, connect the coax and electrical connectors and tighten the retaining nut to the correct torque.
• Reinstall trim/headliner, reconnect the battery and verify radio reception and any amplifier function.

If you are unsure about removing interior trim or working at roof level, have the replacement performed by a qualified technician.

Why The Part Commonly Fails

Common causes of antenna failure include water ingress at the base leading to corrosion, oxidation of the coaxial connector, mechanical damage from impacts or vandalism, and wear of internal cables. In vehicles with an integrated amplifier, electrical faults or moisture can also cause loss of reception. Failure symptoms are weak or intermittent radio signal, static, or complete loss of reception on AM/FM bands.

When replacing the antenna, check the coaxial cable and connector condition and ensure the roof sealing is restored to prevent future water entry.

Product Numbers For Search: 9674768680 | 9810547980 | 658724 | 6587G4 | 6587G3 | 6580J0 | 6561JT | 6561JS

Original PSA roof antenna for Citroën cars, designed primarily for the C3 II. Thanks to the same OEM codes (9666154380, 6561JT, 6561Js, 6587G3), it represents an ideal replacement of the original antenna in the case of impaired radio intake, mechanical damage or leakage over the base. This is the original part removed from the car, suitable for professional car mechanics and home repairers.

The function of the antenna is reliable reception of the radio signal and a stable connection with the car radio. Typical reasons for replacement in these cars include a broken rod, oxidation of contacts, damaged base seals and humidity affected electronics amplification in the heel of the antenna. The replacement usually solves the signal fluctuations, noise and frequent radio outages.

As a rule, the assembly is simple: from the interior of the car, the rear of the ceiling is released, the antenna connector (s) is disconnected, the base matrix of the base is released and the antenna is exchanged with the same part number. When installing, ensure that the sealing between the roof and the base of the antenna to ensure that the water is sealing. After assembly, we recommend testing the radio intake and check that the connector fits firmly.

Compatibility: Primarily for Citroën C3 II. On other dog models, the antenna can be applicable if the OEM codes are equal. Always compare the part number from your original antenna before ordering or verify the compatibility by VIN.

technical information

• Manufacturer: PSA Peugeot Citroën (OEM)
• Model: Citroën C3 II (A51, 2009–2016)
• product codes: 9666154380, 6561JT, 6561JS, 6587G3
• Other numbers: Not specified

It is an older original part used. It is recommended to visually check the status of the seals and contacts before installation. If you are looking for an antenna by the part number, follow the codes – the code match is the safest way to seamless installation and full functionality.