High-Quality Delphi COMEV3 Steering Column Switch Assembly Designed For Citroën And Peugeot Vehicles. This multifunction stalk unit Controls Indicators, Headlights, Fog Lamps, The Trip Computer, Front And Rear Wipers And The Horn. Engineered For Workshop Use And DIY Repairs, The Switch Offers Direct Replacement For Vehicles Using The Listed Part References And Restores Full Steering Column Functionality Without Extensive Modifications.

Compatibility And Fitment

Commonly Compatible With The Following Models (Depending On Vehicle Specification):

• Citroën Berlingo B9
• Citroën C3 Picasso
• Citroën Jumpy / Peugeot Expert III / Jumpy III (Selected Versions)
• Peugeot 308
• Peugeot Partner / Partner Tepee (Partner II / Partner III)

Search Keywords: Steering Column Switch, Stalk Switch, Delphi COMEV3, Citroën Switch, Peugeot Switch, 98062016XT, 12277902, 6242PN.

Technical Information

• Manufacturer: Delphi
• Model(s): Steering Column Switch Assembly (COMEV3)
• Product Codes: 98062016XT
• Other Numbers: 12277902, 6242PN

Replacement Procedure (General Guide)

• Disconnect The Negative Battery Terminal And Wait Several Minutes To Ensure Airbag System Is De-Energized.
• Remove Steering Column Trim Panels To Access The Switch Module.
• Follow Manufacturer Procedure For Airbag And Steering Wheel Removal If Required; Mark Steering Wheel Position Before Removal To Preserve Clockspring Alignment.
• Unplug Electrical Connectors From The Old Switch, Unscrew Fasteners Or Release Clips, Then Remove Unit.
• Install The New Switch In Reverse Order, Ensure Connectors Are Fully Seated And Wiring Is Free From Pinch Points.
• Reassemble Trim, Reconnect Battery, And Check All Functions: Indicators, Lights, Wipers, Horn, And Trip Computer Controls.
• If Steering Wheel Was Removed, Tighten To Manufacturer Torque Specification And Verify Clockspring Alignment Before Reconnecting The Airbag.

Installation Recommendations

• Always Disconnect The Battery Before Starting Work And Wait Long Enough For Capacitors And Airbag Systems To Discharge.
• Observe Proper Airbag Handling Procedures: Work Carefully Around The Airbag Module And Follow Vehicle Manufacturer Instructions.
• Do Not Rotate The Clockspring Excessively When The Steering Wheel Is Removed; Maintain The Original Centered Position.
• Inspect Wiring Plugs For Corrosion Or Damaged Pins And Repair As Needed To Prevent Intermittent Faults.
• After Installation, Verify All Functions On Road Test; Some Vehicles May Require Electronic Checks With Diagnostic Equipment To Confirm Proper System Status.

Most Common Failure Causes

• Wear Of Internal Contacts Due To High Usage (Indicators, Wipers, Horn).
• Ingress Of Moisture Or Dirt Causing Corrosion And Intermittent Electrical Connections.
• Mechanical Damage From Impact Or Excessive Force On Stalks.
• Broken Or Worn Switch Springs Leading To Sticky Or Unresponsive Controls.
• Faulty Connector Pins Or Wiring Harness Issues Causing Loss Of Specific Functions.

This Delphi COMEV3 Steering Column Switch Is A Practical Replacement For Workshops And DIY Enthusiasts Repairing Citroën And Peugeot Steering Controls. Fitment Is Typically Straightforward For Experienced Technicians; When In Doubt, Follow The Vehicle Manufacturer Service Manual For Safe Disassembly And Reassembly.