Product Overview

High-quality replacement instrument cluster (tachometer / gauge cluster) suitable for Citroën C4 II (B7) vehicles. This unit displays speed, engine RPM, fuel level, coolant temperature and on-board warnings and includes the odometer reading. Commonly searched under part numbers 96657316XT, 9812831980, 6103QC and 6103QE — include these codes when searching or ordering to ensure quicker match.

Key Benefits

• Direct Fit For Citroën C4 II (B7) Dashboards — Designed To Match OEM Mounting Points And Connectors.
• Keeps Full Functionality Of Speedometer, Tachometer, Fuel And Temperature Gauges.
• Ideal For Mechanics And DIY Enthusiasts Looking For A Reliable Unit With Known Product Codes.
• Instrument Cluster Supplied From Vehicle With Approximately 110,000 Km — Useful For Mileage Reference And Diagnostics.

Compatibility

Intended For: Citroën C4 II (B7) models. When searching, use product codes 96657316XT / 9812831980 / 6103QC / 6103QE or the label values 6103QC/6103QE to locate matching units. Compatible With Stellantis-Citroën/Peugeot Electrical Systems Typical For C4 II Dash Harnesses.

Technical Information

• Manufacturer: Stellantis (Citroën/Peugeot)
• Model: Citroën C4 II (B7)
• Product Codes: 96657316XT, 9812831980
• Additional Numbers: 6103QC, 6103QE
• Recorded Mileage: Approx. 110000 Km ± 3,000 Km

How To Replace (General Guide)

Replacement of the instrument cluster is a straightforward procedure for a qualified mechanic or a competent DIYer with basic tools. Typical steps:

• Disconnect The Battery Before Starting To Prevent Short Circuits Or Damage To Electronic Modules.
• Remove Trim Panels Around The Steering Column And Dash To Access The Cluster (May Require Removing Steering Column Shrouds).
• Unscrew The Cluster Fasteners (Usually 2–4 Screws) And Carefully Pull The Cluster Forward.
• Unplug The Multiway Connectors And Any Illumination Bulb Sockets.
• Fit The Replacement Unit, Reconnect Connectors, Refit Screws And Trim, Then Reconnect The Battery.
• After Installation, Check All Gauges, Indicator Lights And Warning Messages For Correct Operation.

Installation Recommendations

• Always Disconnect The Battery Prior To Removal/Installation To Avoid Damage To The Cluster Electronics.
• Handle Connectors And PCB Areas Carefully — Avoid Pulling On Wiring Only; Release Connector Locks First.
• Inspect Wiring And Connectors For Corrosion Or Damage While The Cluster Is Out; Repair Any Faults To Prevent Recurrence.
• If The New Cluster Shows Incorrect Mileage Or Immobiliser Messages, Professional Reprogramming Or Data Cloning May Be Required.
• Where Coding Is Necessary, Use Appropriate Diagnostic Equipment And Follow Manufacturer Procedures.

Most Common Failure Reasons

• Electronic Faults On The Cluster PCB Caused By Thermal Cycling Or Ageing Components.
• Stepper Motor Or Gauge Actuator Wear Leading To Erratic Or Stuck Needles.
• Poor Solder Joints Cracking Over Time Causing Intermittent Failures.
• Water Ingress Or Dampness From Leaks Causing Corrosion And Short Circuits.
• Connector Corrosion Or Broken Wiring In The Dash Harness.

Notes

This unit Was Removed From A Vehicle And Has The Mileage Shown Above. Product Codes And Additional Numbers Are Included To Help With Fast Identification. Suitable For Auto Mechanics And Experienced DIYers Who Need A Direct-Fit Instrument Cluster For Citroën C4 II (B7).