Part description

The used Car radio Continental RD45 is a suitable choice for repairing or replacing the original unit in Citroën and Peugeot cars. Parts of this type are often searched for by serial number, so it’s important to keep an eye out for 98053736XT, 1612481780 and 1616145080.

This is an original electronic part that has been tested and is fully functional. With this type of radio, it is necessary to take into account that after installation, it must be connected to the car by diagnostics in order for it to work correctly in a particular car.

Technical information

• Manufacturer: Continental
• Model: RD45
• Other numbers: 1612481780, 1616145080

Product codes

• Product codes: 98053736XT, 1612481780, 1616145080
• Model names: PEUGEOT 3008 I, PEUGEOT 5008 I

Installation recommendations

Generally/typically for car radio replacement, the exact procedure may vary depending on the specific model and design of the car. With this part, it is also necessary to take into account the subsequent assignment of the radio to the car using diagnostics.

1) Before assembly

• Check that all markings on the original and new part match, especially RD45 and the product codes listed.
• Inspect the connectors, pins and radio housing for damage, oxidation or mechanical deformation.
• Compare the mounting points, faceplate and connector equipment with the old piece.
• Disconnect the battery before starting work to avoid damaging the vehicle’s electronics.

2) Necessary tools and materials

• Basic set of hand tools
• Plastic pry bar for panel removal
• Suitable release tools for removing the car radio if needed
• Cleaning agent for electrical contacts
• Soft cloth for cleaning surrounding parts
• Diagnostic equipment for connecting the radio to the car

3) Step-by-step assembly procedure

1. Turn off the ignition and leave the vehicle stationary.
2. Disconnect the battery.
3. Carefully remove the surrounding covers or trim so as not to crack or scratch them.
4. Remove the original car radio using a suitable tool according to the mounting design.
5. Disconnect all connectors and antenna connections from the old radio.
6. Check the condition of the connectors in the vehicle, clean them gently if necessary.
7. Connect the connectors and antenna to the Continental RD45 car radio.
8. Check that the wiring is not pinched or stretched before fully seating it in the dashboard.
9. Place the radio in the mounting position and fix it in the original way.
10. Reinstall all removed covers and trim.
11. Connect the battery.
12. Diagnosticize the radio to the car to ensure proper communication and function.
• 4) Post-assembly checks and function verification
  • Check the power on of the car radio and the basic response of the controls.
  • Verify sound function, radio reception and response to normal controls.
  • Check for non-standard messages or function failures after installation.
  • After the diagnostic assignment, verify that the radio works stably even after turning the vehicle off and on again.

  5) The most common assembly mistakes + how to avoid them

  • Assembly without checking the part marking – always compare the codes and designs of the connectors before installation.
  • Connecting with the battery connected – increases the risk of damaging the electronics, so always disconnect the battery first.
  • Damage to the trim during disassembly – use suitable plastic tools and do not use force.
  • Insufficiently seated connectors – always check for proper engagement after connection.
  • Skip the diagnostic pass-through – for this radio, this step is necessary for proper operation in the car.

  Reasons why the part is damaged

  • Power failures or voltage fluctuations in the vehicle’s electrical system
  • Unprofessional disassembly or assembly and damage to connectors
  • Intrusion of moisture, dust or dirt into electronics
  • Mechanical damage to the front panel or radio cabinet
  • Long-term wear and tear of internal electronic components
  • Interference with cabling or improper connection of accessories
  ]]>