Replacing the engine mount bracket is a straightforward procedure that can typically be completed with basic tools. It’s advisable to inspect this part regularly, especially if you notice unusual vibrations or noises coming from the engine area. Depending on driving conditions, the engine mount may need to be replaced every few years or as per the manufacturer’s recommendation.

Technical Information

• Manufacturer: PSA Group
• Model: Citroën C1, Peugeot 107
• Product Codes: 1813E2
• Other Numbers: 181300

Make sure to use high-quality replacement parts for your vehicle to ensure the best performance and longevity. Whether you’re a professional mechanic or a DIY enthusiast, the Engine Mount Bracket for Citroën C1 and Peugeot 107 is an excellent choice for maintaining your vehicle’s performance.

Product Overview

This heavy-duty A/C compressor bracket secures the air conditioning compressor to the engine block on small city cars from the Citroën/Peugeot/Toyota family. Designed for a precise fit, the bracket restores correct compressor alignment and belt path, ensuring reliable belt drive performance and reducing vibration transfer to the compressor housing.

Who Should Use This Part

Ideal for professional auto technicians and competent DIYers working on Citroën C1, Peugeot 107 or Toyota Aygo models. Often searched and ordered by OE product number, this bracket is a common replacement part in workshops performing A/C, accessory drive or engine-mount repairs.

Function And Typical Failure Modes

Function: The bracket provides a rigid mounting point between the A/C compressor and the engine block, maintaining correct pulley alignment and allowing the drive belt to run smoothly.

Why It Fails: The most common causes of bracket failure are metal fatigue and cracks due to long-term vibration, corrosion in regions with road salt, impact damage from collisions, or stripped/overstressed mounting bolts. Failure symptoms include squealing or slipping belts, visible misalignment of the compressor pulley, unusual vibration from the front of the engine, or oil/bolt thread damage around the mounting area.

Installation Recommendations

• Inspect Compressor And Belt: Before fitting the new bracket, check the compressor housing, pulley, and drive belt for wear or damage. Replace the belt and any damaged tensioners as necessary.
• Use Correct Fasteners: Always use original specification bolts or equivalent quality replacements. Replace any corroded or stretched bolts and washers.
• Tightening Procedure: Tighten fasteners to the manufacturer’s torque settings. If torque values are not available, consult service documentation for the specific engine variant.
• Alignment Check: After installation, spin the accessory belt by hand to ensure pulleys run true and there is no edge contact or misalignment.
• Corrosion Protection: Clean mating surfaces and treat exposed metal with suitable anti-corrosion product if required to extend service life.
• Safety: Support the compressor while removing or fitting the bracket to avoid stress on refrigerant hoses. Avoid disconnecting A/C lines unless qualified and equipped to recover refrigerant.

Technical Information

• Manufacturer: Stellantis
• Model: Citroën C1, Peugeot 107, Toyota Aygo
• Product Codes: 88431-0H010, 6453RL
• Additional Numbers: 6453RL | 88431-0H010

Fitment And Notes

This bracket is intended for the specified small-engine models from Citroën, Peugeot and Toyota sharing the same platform and accessory layout. Confirm visual match with the old bracket and the compressor mounting points before fitting. The part is commonly referenced by OE numbers 88431-0H010 and 6453RL.