Part description

Used wiper motor intended for Peugeot 207 in the wiper mechanism category. It is an electrical component that drives the wiper mechanism – in the event of a malfunction, it is typically manifested by non-functional wiping, irregular operation or stopping in an inappropriate position. If you are looking for a part by number, you can find all product numbers listed in the description below for quick pairing.

Technical information

• Manufacturer: Stellantis (CITROEN / PEUGEOT)
• Model: Peugeot 207
• Other numbers: 3397020769, 6405CH

Product codes

• Product codes: 9650380780, 3397020769, 6405CH

Installation recommendations

Generally/typically for this type of part, the exact steps may vary depending on the specific car design and wiper mechanism used.

1) Before assembly (checks of the used part, what to compare with the old part)

• Check if the part number (9650380780, or 3397020769, 6405CH) matches the old engine or the marking on the original part.
• Compare connector (shape, number of pins, locking) and mechanical attachment.
• Inspect the motor body for cracks, damage to the threads/mounts and the condition of the contacts (oxidation).
• Make sure the wiper mechanism is not hardened/rusted – overstressing will often destroy even a new motor.

2) Necessary tools and materials (in general, without specific extra parts)

• Basic set of keys and sockets
• Screwdrivers / plastic pry bar for removing covers and upholstery
• Pliers, or a small clip hook
• Electrical contact cleaner (recommended)
• Protective gloves, rag

3) Step-by-step assembly procedure

1. Turn off the ignition and secure the vehicle against movement.
2. Disconnect the negative terminal of the battery (recommended for electrical parts due to short circuits and installation errors).
3. Get access to the wiper motor by removing the relevant covers/trimmings (depending on the car model).
4. Disconnect the motor electrical connector – do not pull on the wiring, release the connector fuse first.
5. Mark the position/placement of the part (e.g. cable routing and mounting) so that the installation is the same.
6. Undo the motor mounting screws/mounts and remove the motor.
7. Check the condition of the mechanism, rods and moving parts – they must move freely, without binding.
8. Clean the connector contacts and the attachment area from dirt and corrosion.
9. Install the motor in its original place and secure it with fasteners.
10. Connect the electrical connector and check that the latch clicks properly.
11. Reinstall all the removed covers/trims and check that nothing rubs and the wiring is not pinched.
12. Connect the battery.
• 4) Post-assembly checks and test drive/function verification
  • Verify the function of the wiper in all available modes (switching, interval, return to rest position – depending on the car’s equipment).
  • Check if the operation is slow, irregular or excessively noisy.
  • After a short drive, double check that everything is firmly attached and that the trim has not come loose anywhere.

  5) The most common assembly mistakes + how to avoid them

  • Pinched or twisted wiring – run the harness as originally and check the grommets.
  • Non-snap connector – always pull gently after plugging in to verify locking.
  • Assembly without checking the mechanism – stiffened mechanism overloads the motor and shortens its life.
  • Contaminated/oxidized contacts – clean the connector, you will prevent blackouts and transient resistances.

  Reasons why the part is damaged

  • Stiff wiper mechanism (corrosion, dirt) → the engine is working in overload.
  • Water and moisture in the engine compartment → corrosion, short circuits, damage to electronics/commutator.
  • Wear of carbons and commutator in older pieces.
  • Oxidation of connectors and increased transition resistance → blackouts or overheating.
  • Mechanical damage during unprofessional disassembly (broken handles, damaged connectors).
  ]]> https://www.usedpartsvendor.com/electro-components/wiper-mechanisms/207-wiper-mechanisms/peugeot-207-rear-wiper-motor-0390201813-9652418780/ Wed, 14 Jan 2026 03:00:39 +0000 https://www.usedpartsvendor.com/uncategorized/peugeot-207-rear-wiper-motor-0390201813-9652418780/ Rear wiper motor for PEUGEOT 207 cars

  Part description

  Used rear wiper motor designed for Peugeot 207. It is an electrical component from the category of wiper mechanisms, which ensures the drive of the rear wiper and thus the correct function of wiping the rear window. Thanks to traceable part numbers, it is suitable as a replacement in the event of a malfunction of the original motor, when the wiper does not work, works irregularly or stops.

  Technical information

  • Manufacturer: Stellantis (CITROEN / PEUGEOT) / not specified
  • Model: Peugeot 207
  • Other numbers: 6405AN

  Product codes

  • Product codes: 0390201813, 9652418780

  Installation recommendations

  Generally/typically, the following procedure applies to replacing the rear wiper motor (exact steps may vary depending on the specific car model):

  1) Before assembly

  • Compare the part numbers from the tag/casting: 0390201813, 9652418780 and possibly 6405AN with the old piece.
  • Check the connector(s): same shape, number of pins, undamaged securing.
  • Inspect the motor body and the area around the output (shaft/axle): no cracks, no signs of leakage and significant corrosion.
  • If a bearing surface/seal is included, check that it is clean and undamaged.

  2) Necessary tools and materials

  • Basic set of ratchets and extensions / keys
  • Screwdrivers / torx bits (according to design)
  • Plastic crowbar for removing upholstery/covers
  • Contact cleaner (recommended), cloth
  • Protective gloves

  3) Step-by-step assembly procedure

  1. Turn off the ignition and disconnect the battery for safety reasons.
  2. Provide access to the rear wiper motor by removing the necessary internal covers/trimming at the mounting location (typically plastic parts – be careful not to break the mounts).
  3. Disconnect the electrical connector from the engine – release the connector lock first.
  4. Remove the engine fasteners (bolts/nuts depending on design).
  5. Remove the original motor and check around the mount (cleanliness, traces of water, corrosion).
  6. Clean the contact surface and possibly the connector/pins (contact cleaner should be used).
  7. Install the used motor in its original position and fit the fasteners.
  8. Tighten the fasteners adequately and evenly so that the motor fits properly and there is no tension.
  9. Connect the electrical connector and verify proper snapping/locking.
  10. Reinstall the removed covers/trims.
  11. Connect the battery.

• 4) Post-assembly checks and test drive/function verification

  • Check that the rear wiper runs smoothly and does not stop.
  • Check for unusual noises (scratching, skipping) that may indicate a problem with the mechanism or attachment.
  • After a short drive/test, visually check the connector and motor mount again.

  5) The most common assembly mistakes + how to avoid them

  • Part swap by appearance – always compare numbers 0390201813 / 9652418780 (and 6405AN if listed).
  • Not clicked connector – leads to outages; check the arrest after connecting.
  • Damage to the plastic cover handles – use a plastic pry bar and proceed without violence.

  Reasons why the part is damaged

  • Leakage and moisture in the engine compartment – corrosion, oxidation of connectors and internal engine damage.
  • Mechanical overload (stuttering of the mechanism, increased wiper resistance) – the engine overheats and its service life is shortened.
  • Wear due to age and frequent use.
  • Electrical problems (increased transient resistance in connectors, damaged wiring) – erratic operation and overheating.
  ]]> https://www.usedpartsvendor.com/electro-components/wiper-mechanisms/207-wiper-mechanisms/peugeot-207-sw-9684626780-53031012-6405ja/ Fri, 11 Jul 2025 02:03:03 +0000 https://www.usedpartsvendor.com/uncategorized/peugeot-207-sw-9684626780-53031012-6405ja/ This rear wiper motor is designed specifically for CITROEN PEUGEOT vehicles.
  It is sourced from a Peugeot 207 SW model equipped with an opening rear window.

  Looking for a reliable rear wiper motor for your Peugeot 207 SW? This used car part is an excellent choice if you perform repairs yourself or work as a mechanic. Originating directly from the Peugeot 207 SW with an opening rear window, this wiper motor provides the functionality and durability essential for safe driving in all weather conditions.

  The rear wiper motor is a crucial component for maintaining a clear and unobstructed view during rain or other challenging weather. It ensures the rear wiper effectively removes water and dirt from your rear window.

  Technical Information

  • Manufacturer: PSA Citroen Peugeot
  • Model: Peugeot 207 SW
  • Product Codes: 9684626780, 53031012, 6405JA
  • Additional Numbers: NFP

  Replacing a worn or malfunctioning rear wiper motor is straightforward with this part, restoring full rear wiper functionality. This component is frequently searched for due to its specific fitment and compatibility with the Peugeot 207 SW model. Installing the correct rear wiper motor ensures your rear window stays clean, improving visibility and overall safety while driving your vehicle.

  ]]> https://www.usedpartsvendor.com/electro-components/wiper-mechanisms/207-wiper-mechanisms/peugeot-207-sw-6405-is-mechanism/ Fri, 11 Jul 2025 02:03:03 +0000 https://www.usedpartsvendor.com/uncategorized/peugeot-207-sw-6405-is-mechanism/ Rear Wiper Motor Mechanism for PSA Citroen Peugeot vehicles.
  Specifically designed for the Peugeot 207 SW model equipped with an opening rear window.
  The bearing is free-moving but fully functional.

  Are you looking for a dependable rear wiper motor mechanism for your Peugeot 207 SW? This high-quality used part is the perfect solution to replace a damaged or malfunctioning rear wiper motor. It carries the 6405JE part number, known for its long-lasting reliability and performance.

  This mechanism was removed from a Peugeot 207 SW featuring an opening rear window. Despite a free-bearing condition, its functionality remains unaffected, ensuring it performs its essential role effectively. The rear wiper motor mechanism is crucial for maintaining a clear and clean rear glass, which is vital for safe driving under adverse weather conditions.

  Technical Information:

  Manufacturer: Citroen Peugeot
  Model: Peugeot 207 SW
  Product Codes: 6405JE
  Additional Numbers: NFP

  Spare parts like this are essential for keeping your vehicle safe and fully operational. This component has been carefully inspected to guarantee full working condition, providing dependable service for the future. Restore the functionality and reliability of your Peugeot 207 SW rear wiper with this outstanding part.

  Don’t hesitate to renew your vehicle’s rear wiper mechanism today. This part is ready for immediate installation and can withstand real-world driving conditions, ensuring peace of mind even in the worst weather scenarios.

  ]]> https://www.usedpartsvendor.com/electro-components/wiper-mechanisms/207-wiper-mechanisms/wiper-motor-peugeot-207-sw-9680904480-53031512-6405jc/ Mon, 23 Jun 2025 02:03:09 +0000 https://www.usedpartsvendor.com/uncategorized/wiper-motor-peugeot-207-sw-9680904480-53031512-6405jc/ Rear wiper motor designed for CITROEN PEUGEOT vehicles, specifically from the Peugeot 207 SW model.

  Dear Customer, we present the rear wiper motor for Peugeot 207 SW, an essential component ensuring your vehicle’s optimal functionality. This used auto part comes directly from the Peugeot 207 SW, guaranteeing compatibility and straightforward installation.

  The wiper motor provides smooth and quiet operation of the rear wiper, which is crucial for maintaining clear visibility in adverse weather conditions. Installation is relatively simple and can be performed by both professional mechanics and experienced DIY enthusiasts, saving time and costs on specialized service.

  Technical Information:

  Manufacturer: PSA Citroen Peugeot
  Model: Peugeot 207 SW
  Product Codes: 9680904480, 53031512, 6405JC
  Additional Numbers: The component is marked according to Peugeot manufacturer specifications with codes 9680904480, 53031512, 6405JC, ensuring its authenticity and quality.

  This rear wiper motor is a highly sought-after replacement part due to its vital role in safe driving. It is a quality-checked used part offering a reliable and cost-effective alternative to new components, with guaranteed long-term functionality.

  ]]>